Issues with Apollo BTC Node Setup

hey everyone just set up my apollo full node and a standard one today everything was cool at first, logged into the dashboard no prob... then updated it to 0.3.4 but when I checked later, my node wasn’t running. waited like 15 mins to start it but it wouldn’t budge so I checked the m.2 card and shut down the apollo from the dashboard. m.2 seemed fine, but when I turned it all back on, now it’s not showing up on the network... the red light's on and the fan's dead hooked up a monitor and mouse, but nothing shows up, what’s going on?

sounds like you might’ve messed up the m.2 connection when you unplugged it try this: - take out the m.2 drive again and put it back in properly - if that doesn’t help, check for dirt or rust on the terminals, maybe clean it with some isopropyl alcohol or a pencil eraser, then plug it back in and see if it works