Issues with Avalon 116 Pro75 Performance

Miner log shows some weird stuff..

Everything seems fine temp-wise. Did you tweak the work mode in your pool settings? If it's set to normal, high performance won't kick in. If you set it to high performance, it should be working fine.

Can you share the aging fms code?

Tried upgrading the firmware but still nothing. Need help.

This log is showing high performance but hashing like it’s in normal mode, under 40 hash.

Check the FMS tool for the aging button. Maybe you downloaded the wrong version? Try the FMS app dated 2020.10.29. If it still doesn’t work, use this command I found.

Thanks, I’ll give it a shot and keep you updated.

Applied the aging code, but it’s even worse now, only hitting 15 TH. Can I revert by reflashing the firmware? Help!

After aging, tmax also increased. What should I do?

That’s rough, doesn’t sound good. There might not be a way to revert, but seriously, make sure you use the right FMS tool for aging. It usually takes 20 minutes to an hour. Don’t reboot while it’s aging. Let it finish, then check back here.

Just did the aging again with FMS. In normal mode, I'm hitting 40-45 TH, but in high performance, only about 60, not reaching 75. I have another rig that does 60-70 in normal. Log shows my voltage around 303-310. What's up?

How long have you had this miner?

It's new, got it from a friend, only been running it for two weeks.

Since you have another running well, why not swap the PSUs and see if that’s the issue? Or even try swapping hashboards, maybe you got a defective one.

Thanks for the suggestion, I'll try that.

Same issue. Could high ping be affecting it? I’m at 378 ms.

Is the other rig mining on the same pool? If it is, then it’s probably not the ping causing your issue.

Sounds like you’re still stuck after swapping the PSU and hashboards. Maybe it’s time to change the control board instead.

Or get a pro to check it out. You can look for repair services nearby.

High ping on one rig and not the other? Might point to control board issues or the firmware. Or it could just be a bad ethernet cable. I'm out of ideas after that.